![]() ![]() Change value of parameter 30 to number of sequence slot you want to fill (1 to 6).To perform automatic learning of a sequence: Two identical gestures cannot be used next to each other.Sequence can consist of two or three basic gestures (left, right, up or down).Maximum of six sequences can be created.31-36) with 16 bits, every basic gesture is identified with 4 bits. Every sequence is saved in its advanced parameter (no. User can create sequences of two or three gestures to expand number of possible actions. The device is ready to detect gestures.Move your hand close to the centre of the pad.Operation of power saving mode can be modified in parameter 6. In Standby Mode range and frequency of detection are reduced preventing normal gesture detection. When battery powered, the Swipe will enter Standby Mode by default (signalled with a low pitch beep) after 5 seconds of inactivity to reduce the battery usage. In this mode batteries will work as an emergency supply. The device in this mode uses power saving function to preserve battery life.Įxternal supply mode – the Swipe can be supplied with a 5V DC power supply connected to the micro-USB port. They are not rechargeable and should be replaced after wearing out. Battery powering mode – by default, the Swipe is supplied with 4 batteries included with the device (type AA 1.5V). The device does not work as a Z-Wave repeater, even when connected to the external power supply. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |